The AG966-07E provides easy connections to an ASR012-10E I2C/PWM TMR Smart Angle Sensor. In addition to the sensor, the board has a recommended bypass capacitor and a six-pin header connected to each of the sensor I/O pads.
The board is approximately 0.5 by 0.6 inches (12 x 15 mm).
The AG968-07E provides easy connections to an SM228-10E Smart Magnetometer. In addition to the sensor, the board has a recommended bypass capacitor and a six-pin header connected to each of the sensor I/O pads.
The board is approximately 0.6 by 0.75 inches (15 x 19 mm).
This self-contained module allows zeroing and programming the digital output threshold and hysteresis or SM124-10E or SM125-10E Smart Magnetometer without need of a computer or a customer microcontroller.
The 2.5" x 2.5" (64 mm x 64 mm) board has an I²C master microcontroller connected to the SM124.
A pushbutton for zeros the sensor, and miniature rotary thumbwheel switches provide three digits of resolution for the threshold and two for hysteresis. A custom TDFN-6 socket accommodates the 2.5 mm x 2.5 mm SM12x-10E. The module is powered by a small wall-mounted power supply (included).
Jumpers allow the sensor to be disconnected from the rest of the board so the board can be used as an interface to the customer’s electronics.
This module includes:
A 2.5 x 2.5 mm TDFN6 socket for a SM12x-10E Smart Magnetometer
A preprogrammed, onboard microcontroller
Two sets of thumbwheel switches for digital threshold and hysteresis
Two LEDs indicating the sensor’s output and successful programming
The AG975-07E provides easy connections to an SM223-10E high-sensitivity Smart Magnetometer. In addition to the sensor, the board has a recommended bypass capacitor and a six-pin header connected to each of the sensor I/O pads.
The board is approximately 0.6 by 0.75 inches (15 x 19 mm).
The AG976 demonstration board includes an ASR003-10E sensor, a diametrical magnet, magnet fixturing, and an interface board with a microcontroller. Four variable-brightness LEDs show the magnetic field strength in each direction.
Easy-to-install Windows software provides a graphical user interface showing the sensor output and allowing sensor parameters to be programmed.
The AG977-07E provides easy connections to an ASR003-10E TMR Smart Angle Sensor. In addition to the sensor, the board has a recommended bypass capacitor and a six-pin header connected to each of the sensor I/O pads.
The board is approximately 0.5 by 0.6 inches (12 x 15 mm).
The SM124-10E Smart Magnetometer combines an omnipolar GMR sensor element with
with easy-to-use digital signal processing.
A digital output provides precise, programmable thresholds.
An I²C interface provides magnetic field data, as well as a
calibration interface. The device is factory calibrated for accuracy. Calibration coefficients are stored in internal nonvolatile memory.
All commands, data, and coefficients are a single byte, and a
slick, elegant data structure lets you get up and running with
a minimum of firmware.
Key features include:
Can detect magnets more than 50 mm away
I²C and digital threshold outputs
0-1 mT linear range
8-bit / 1% output resolution
−40°C to +125°C operating range
5% FS accuracy for 0 to 85°C
10 kSps sample rate for fast response
6 mA typical supply current
In-plane sensitivity more usable than Hall effect sensors
Programmable offset and gain compensation
Optional magnet temperature compensation
2.2 to 3.6 volt supply
Ultraminiature 2.5 x 2.5 x 0.8 mm TDFN package