New Products

Displaying 161 to 180 (of 408 products)
IL012-3E: Low-Power, 2-Channel (1 each direction) Isolator, 2.5 kV, SOIC8

The IL012-3 is a low-power, 3.3/5V, 10 Mbps, 100C Isolator. Typical total quiescent current is just 0.3 mA per channel. 8-pin SOIC package.

Part Number:
IL012-3E
Quantity in Stock:
19

$6.29

AG935-07E: 60-LED "Blinky" AAT003 Angle Sensor Demo Board

This kit includes a 5-inch by 5-inch circuit board with an AAT003 Angle Sensor, 60 multicolor smart LEDs (6° spacing) to indicate rotation angle, and a preprogrammed, onboard ATtiny microcontroller. The microcontroller also provides a PWM angle output. The board is factory calibrated and can optionally be field calibration. A split-pole magnet, a magnet locating fixture, and a 5-volt wall mount power supply module are also included. The board comes preprogrammed, but the Arduino compatible software is available on Github/NveCorporation so you can use the routines in your own application.

Part Number:
AG935-07E
Quantity in Stock:
2

$150.00

AAL024-10E: 1.5 mT Noncontact Current Sensor, 2.2 KOhm, TDFN6

The AAL024-10E high-performance magnetometer has high sensitivity, high linearity, low-hysteresis, and cross-axis sensitivity, making it ideal for noncontact current-sensing. Features: 3.6 mv/V/Oe typical sensitivity for large output signals and low noise Wide linear range: 0.15 – 1.05 mT; 1.5 mT saturation 2.2 kΩ bridge resistance/1.1 kΩ output impedance for easy interface Low offset: 4 mV/V max. Low hysteresis: 2% max. for excellent repeatability Wide bandwidth: 100 kHz 63 V minimum inherent isolation (pad to electrical connections) Ultraminiature 2.5 mm x 2.5 mm TDFN6 package Applications: Current sensing Low-field sensing for magnetic media Earth’s magnetic field detection Low-Hysteresis Magnetometer—
senses fields from permanent magnets, earth, and current sources.  Typ. Saturation Field (Oe)   Linear Range(|Oe|) 
min.-max.  Sensitivity (mV/V/Oe) 
min.-max.  Resistance 
(Ohms)  Package  15 1.5 - 10.5 3.0 - 4.2  2200 ±20%  TDFN6
(RoHS) Note: Parts are sold in increments of 100 for quantities of 100 or more.
This part is RoHS compliant.

Part Number:
AAL024-10E
Quantity in Stock:
7859

$9.60

AG919-06: MSOP8 PCB (2" x 0.25"; cross-axis orientation)

The AG919-06 is a 2 x 0.25 inch (50 x 6 mm) PCB designed to be used with MSOP8 sensors (-00E package; order sensors separately). The MSOP8 is rotated 90 degrees compared to the AG918-06.

Part Number:
AG919-06
Quantity in Stock:
6

$4.25

AA007-00E: 50 mT Sat. Analog Sensor, 5 KOhm, RoHS MSOP

The AA007-00E GMR Magnetic Field Sensors are used to sense relatively high fields. 0.1 mV/V/Oe Sensitivity; 500 Oe Saturation Field; MSOP8.
Note: Parts must be purchased in tube quantities (multiples of 100) when purchasing quantities of 100 or more. Larger quantities are subject to NVE's standard lead times.

Part Number:
AA007-00E

$9.60

AG904-06: ULLGA General-Purpose PCB

A 1.2 x 0.25 inch x 0.031 inch thick (30 x 6 x 0.75 mm) PCB for demonstrating 1.1 x 1.1 mm ULLGA4 sensors (-14E sensor suffix; order sensors separately).

Note that since these boards use very small sensors, they require reflow or hot-air soldering techniques.

Part Number:
AG904-06
Quantity in Stock:
237

$5.00

AG039-06: ULLGA Digital Sensor Demonstration Bare Board

A 1.57 x 0.25 inch PCB for demonstrating ADLxxx-14E/AHLxxx-14E 1.1 x 1.1 mm ULLGA4 digital sensors (order sensors separately). In addition to space for the sensor, the boards have locations for 0402-size pull-up resistors and bypass capacitors.

Note that since these boards use very small sensors, they require reflow or hot-air soldering techniques.

Part Number:
AG039-06
Quantity in Stock:
466

$5.00

AG911-07E: GMR Switch Evaluation Kit

AG911-07 kit includes several MSOP GMR Switches with different magnetic operate points and different output options such as current sink and current source. A magnet and circuit boards for mounting the parts are included.

Part Number:
AG911-07E
Quantity in Stock:
11

$65.00

AG910-07E: GMR Switch Evaluation Kit w/ZIF socket

AG910-07 kit includes several MSOP GMR Switches with different magnetic operate points and different output options such as current sink and current source. Magnets, circuit boards for mounting the parts, and a zero insertion force (ZIF) socket are also included.

Part Number:
AG910-07E
Quantity in Stock:
10

$90.00

AG934-07E: AAT101 Full-Bridge Angle Sensor Evaluation Kit

The kit includes a circuit board with an AAT101-10E Full-Bridge Angle Sensor, which provides two differential analog outputs, 90 degrees out of phase. The circuit board can be powered with a 0 V to 5.5 V power supply. An angular reticle on the circuit board aids in characterizing output versus angle. The kit also includes a split-pole magnet and a plastic magnet locating fixture. The AAT101-10E Angle Sensor typical output amplitude is 400 mV/V peak-to-peak for each output.

Part Number:
AG934-07E
Quantity in Stock:
1

$75.00

AAK001-14E: 400 mT Sat. High-Field Magnetometer, 3.5 KOhm, ULLGA

The AAK001-14E is a high-field magnetometer sensor that provides precise sensing of magnetic fields up to 4 kOe (400 mT). With a unique 1.1 mm x 1.1 mm package package, it is also our smallest analog sensor. Features: Precise sensing of magnetic fields up to 4 kOe (400 mT)
Sensitive to fields of any direction in the IC plane
Ratiometric Wheatstone bridge outputs
Any operating supply voltage up to 12V
Ultraminiature 1.1 x 1.1 mm package Applications: Brushless DC motors
Motor commutator sensors
Noncontact high-current measurement
Harsh industrial applications Note: Parts are sold in increments of 100 for quantities of 100 or more.
This part is RoHS compliant.

Part Number:
AAK001-14E
Quantity in Stock:
24

$17.05

AFL006-10E: 0.4 mT Digital Sw, 0.9 V – 2 V, Norm OFF Sinking, TDFN

The AFL006-10E is the world's most sensitive magnetic switch. The switch is designed for use in low power and battery applications. It can operate from a single cell with supplies as low as 0.9 V and typical supply current of 55 microamps. Like all NVE magnetic sensors, the AFL006-10E has extremely precise magnetic operate and release points. Features: 4 Oe typical operate point for ultrahigh sensitivity 0.9 V – 2 V operating voltage for single-cell battery operation Less than 100 microwatts power consumption 2.5 mm x 2.5 mm x 0.8 mm TDFN6 for miniaturization Applications include: Portable instruments Utility meters Noncontact overcurrent protection Note: Parts must be purchased in multiples of 100 for quantities of 100 or more. Larger quantities are subject to NVE's standard lead times. This part is RoHS compliant.

Part Number:
AFL006-10E
Quantity in Stock:
195

$9.25

AAT101-10E: Full-Bridge Angle Sensor, 625 kOhm, TDFN6

AAT101-10E Angle Sensors use a Tunneling Magnetoresistance (TMR) full-bridges to produce a very high output signal without amplification. The sensors also have a wide airgap tolerance and high device resistance for low power. Sine and cosine outputs provide full quadrature. Key specifications are as follows: Full-Bridge TMR Angle Sensor Typ. p-p
Signal  Configuration   Min. Applied 
Field  Nonsinusoidality 
accuracy  Max. Op. 
Temp.  Typ. Device 
Resistance  Package   400 mV/V  Full bridge 30 Oe 1.5% 125°C 625 kΩ TDFN6 The angle sensors are typically used with a split pole magnets such as NVE part no. 12249 or 12426. An Evaluation Kit is available with an angle sensor, circuit board, unity-gain buffer amplifier, split-pole magnet, and a plastic magnet locating fixture. Note: Please purchase in increments of 100 when purchasing quantities of 100 or more.

Part Number:
AAT101-10E
Quantity in Stock:
19880

$8.94

AAL004-10E: 1.5 mT Sat. Analog Sensor, 2.2 KOhm, TDFN6

The AAL004-10E high-performance magnetometer has high sensitivity and low-hysteresis, making it ideal for low-field applications. With a unique TDFN6 package, it is also our smallest analog sensor. Features: Output linear with magnetic fields as low as 1.5 Oe for low-field applications 3.5 mv/V/Oe typical sensitivity for large output signals and low noise 2% maximum hysteresis for precision and repeatability Omnipolar output for configuration flexibility –40 to 125°C Applications: Current sensing Low-field sensing for magnetic media Earth’s magnetic field detection Low-Hysteresis Magnetometer—
senses fields from permanent magnets, earth, and current sources.  Typ. Saturation Field (Oe)   Linear Range(|Oe|) 
min.-max.  Sensitivity (mV/V/Oe) 
min.-max.  Resistance 
(Ohms)  Package  15 1.5 - 10.5 3.0 - 4.2  2200 ±20%  TDFN6
(RoHS) Note: Parts are sold in increments of 100 for quantities of 100 or more.
This part is RoHS compliant.

Part Number:
AAL004-10E
Quantity in Stock:
17523

$9.60

IL3685-1E: 40 Mbps Isolated RS485 Transceiver, 2.5 kV, QSOP

The IL3685-1 is the industry's fastest isolated RS-485 transceiver (40 Mbps) in the industry's smallest package (QSOP16). 3.3 V or 5 V input logic; fully PROFIBUS compliant; 15 kV bus ESD protection; 50 kV per microsecond transient immunity. This part is lead (Pb) free.

Lead-free product information

Part Number:
IL3685-1E
Quantity in Stock:
3639

$6.89

IL3022E: Low-Cost Isolated RS422 Transceiver, 2.5 kV, Wide SOIC

The IL3022E is a cost-effective isolated 4 Mbps RS-422 full-duplex transceiver, compatible with 3.3 V or 5 V input logic. 7 kV bus ESD protection; 50 kV per microsecond transient immunity. 16-pin wide-body SOIC package with True 8™ mm creepage.

Part Number:
IL3022E
Quantity in Stock:
13897

$5.05

AAT006-10E: Low-Field Angle Sensor, TDFN6

AAT006-10E Angle Sensors use Tunneling Magnetoresistance (TMR) technology for operation at magnetic fields as low as 15 Oe, allowing an extremely wide airgap tolerance. The device has a large output without amplification, and high device resistance for low power. Sine and cosine outputs provide full quadrature. Key specifications are as follows: TMR Angle Sensor Typ. p-p
Signal Min. Applied
Field (Oe) Max. Angular
Error (const. field) Max. Op.
Temp. Typ. Device
Resistance Package  200 mV/V  15 Oe 0.5 degrees 125°C 1.25 MΩ TDFN6 The angle sensors are typically used with a split pole magnets such as NVE part no. 12249 or 12426.

Part Number:
AAT006-10E
Quantity in Stock:
15000

$8.94

AG040C: ADL021 Externally-Powered Nanopower Sensor Evaluation Board

This kit includes an evaluation board with the ultraminiature, ultralow-power ADL021 magnetic switch. The board has a digital output, and can be powered from a 3.3-volt nominal supply. An LED shows the output. A miniature bar magnet is included so you can see for yourself how these remarkable sensors work. Typical sensor quiescent current is only 100 nA, the sensor operate point is 20 Oe, and the sensors are 1.1 mm x 1.1 mm. These miniature evaluation boards are just 0.25 x 1.57 inches (6 x 40 mm).

Part Number:
AG040C
Quantity in Stock:
27

$16.95

AG040B: ADL021 Battery-Powered Nanopower Sensor Demonstration Board

This kit includes a demo board with the ultraminiature, ultralow-power ADL021 magnetic switch. An LED shows the sensor output. The board is powered by a three-volt lithium coin cell (included), and the sensor quiescent power consumption is so low that the battery will last indefinitely. A miniature bar magnet is included so you can see for yourself how these remarkable sensors work. Sensor quiescent current is only 100 nA typical; the sensor operate point is 20 Oe; and the sensors are 1.1 mm x 1.1 mm. These miniature evaluation boards are just 0.25 x 1.57 inches (6 x 40 mm).

Part Number:
AG040B
Quantity in Stock:
31

$19.95

AG941-07E: ADL-Series Sensor Demo Board

The kit includes a demo board with three ultraminiature, ultralow-power ADL-Series magnetic sensors. Each sensor drives an indicator LED, and a meter shows the sensor power in microamps or nanoamps. A miniature bar magnet is included so you can see for yourself how these remarkable sensors work. The evaluation boards are 3.75 x 5 inches (95 x 127 mm), and are powered by a coin cell (included).

Part Number:
AG941-07E
Quantity in Stock:
3

$90.00

Displaying 161 to 180 (of 408 products)