The AG954-07E provides a socket for easy programming and prototyping of TDFN6 devices without soldering and unsoldering.
The custom socket is compatible with NVE's 2.5 mm x 2.5 mm TDFN6 package parts (-10E suffixes).
The board is 1.5" x 2" (38 mm x 50 mm), and uses brass hardware to minimize magnetic interference with the socketed sensor.
A 0.1"-spaced header provides for connections to the sensors, and a row of 0.1"-spaced through-holes allows for auxiliary parts such as a decoupling capacitor or an LED.
The AG957-06E provides easy connections to an ASR-Series Smart Angle Sensor (sensors sold separately). In addition a spot for the sensor, the board has a spot for a bypass capacitor and a header to connected to the sensor I/O pads.
The board is approximately 0.5 by 0.6 inches (12 x 15 mm).
The 12032 is a 1.0" long x 0.125" wide x 0.39" thick Y25 ferrite bar magnet. Typical
field strength is 1800 Oe at the magnet face.
This magnet is also included in the AG910-07
GMR Switch Evaluation Kits.
A 1.57 x 0.25 inch PCB for demonstrating ADLxxx-14E/AHLxxx-14E 1.1 x 1.1 mm ULLGA4 digital sensors (order sensors separately). In addition to space for the sensor, the boards have locations for 0402-size pull-up resistors and bypass capacitors.
Note that since these boards use very small sensors, they require reflow or hot-air soldering techniques.
The AG005-06 Printed Circuit Board is a 0.5 x 0.5 inch (13 x 13 mm) PCB with SOIC8 solder pads and through holes for wires or a connector. The PCB allows easy connections to AA-Series SOIC8 sensors (-02E suffix; order separately).
This PCB is also included in the AG001-01 Analog Sensor Evaluation Kit.